Features

Enables full throttle gear shifting in 50-70ms without clutch use. This F series Quickshifter system is self powered by an internal 9v PP3 battery and is a full specification quickshifter which allows you to shift up gears at constant or full throttle without the use of the clutch for ultra fast up-shifts at any RPM.   This system allows the rear tyre to maintain traction under maximum acceleration when shifting up the gears and is an ideal tool for those all important hole shot starts. 

Typically 3 yards can be gained per gear shift and a saving of around 200ms can be made per gear shift for those long staightaways.  The special long Linear sensor is designed to keep the body section of the sensor out of reach of the rocks and debris and away from the mud packed gear lever and boot area.  It features a triple seal design with anti-vibration construction for superior longevity, also a rugged stainless steel 6.0mm diameter shaft sensor shaft.

General information
This Quickshift is micro controlled and therefore does not require any programming or adjusting.  The Quickshifter ECU is positioned up near the top yoke via the supplied mounting bracket.   This system has a simple 2 wire hook-up either to the engine stop switch wires or the pick-up signal generator wires.    

The Linear sensor is mounted between the gearlever and the engine/chassis, in some cases we have developed mounting brackets for bike specific application.

There is a ladder frame bracket supplied as standard to enable effective installations to be carried out, however we recommend the optional YZF450 bracket shown below.

The long Linear sensor monitor the position of the gear lever for precise quickshifting and offer repeatable quickshift switching to 0.1mm